![]() Query-identity keyword is configured, the FlexVPN server queries the EAP identity from the client otherwise, the FlexVPN client’s IKEv2 identity is used as the EAP identity. FlexVPN clients authenticate using EAP by skipping the AUTH payload in the IKE_AUTH request. The FlexVPN server is configured to authenticate FlexVPN clients that use EAP by configuring theĪuthentication remote eap command in IKEv2 profile configuration mode. While a FlexVPN client authenticates the FlexVPN client using EAP, the FlexVPN server must authenticate the FlexVPN server by using certificates. The backend EAP server is typically a RADIUS server that supports EAP authentication. The FlexVPN server supports peer authentication using the Extensible Authentication protocol (EAP) and acts as a pass-through authenticator relaying EAP messages between the client and the backend EAP server. Information About the FlexVPN Server Peer Authentication Using EAP Vrf definition command with IPv4 and IPv6 address families inside the definition. Vrf forwarding vrf-name command to define the IVRF of the tunnel interface, where the Ip vrf forwarding command to configure an Inside VPN routing and forwarding (IVRF) instance because this is not a valid configuration. When configuring a dual-stack tunnel interface in a VPN routing and forwarding (VRF)-aware IPsec scenario, you cannot use the Restrictions for the FlexVPN Server Dual-Stack Tunnel Interface and VRF-Aware IPsec Navigator to find information about platform support and Cisco software image Which each feature is supported, see the feature information table. The features documented in this module, and to see a list of the releases in Release notes for your platform and software release. May not support all the features documented in this module. Next Generation Encryption (NGE) white paper. For more information about the latest Cisco cryptographic recommendations, see the Security threats, as well as cryptographic technologies to help protect against such threats, are constantly changing. This module describes FlexVPN server features, IKEv2 commands required to configure the FlexVPN server, remote access clients, and the supported RADIUS attributes. Feature Information for Configuring the FlexVPN Server.Additional References for Configuring the FlexVPN Server.Example: Configuring the FlexVPN Server for IPv6 Session with IPv6 Configuration Attributes.Example: Configuring the FlexVPN Server for User Authorization.Example: Configuring the FlexVPN Server for Group Authorization (Local AAA).Example: Configuring the FlexVPN Server for Group Authorization (External AAA).Example: Configuring the FlexVPN Server to Authenticate Peers Using EAP.Example: Configuring the FlexVPN Server.Configuration Examples for the FlexVPN Server.Configuring the IKEv2 Authorization Policy.Configuring the IKEv2 Profile for the FlexVPN Server.Dual-Stack Tunnel Interface and VRF-Aware IPsec.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |